Running in
A new AGM scooter, as of course goes for all new vehicles, must be runned in. Running in improves the suppleness of the vehicle and gives the vehicle the possibility to get started calmly. All parts of the scooter are developed accurately and are made to fit. Nevertheless, the metal moving parts of the scooter will only fit exactly after driving with the scooter. This is exactly what happens with running in: the moving parts are being polished so that the engine will run as smoothly as possible. In time, this will make a big difference in the oil use, performance and the life span of the scooter.

Guidelines
To run in the AGM scooters, we advise the following guidelines:

Until the first periodic service (at 250 km) the driving speed of 30 km/hour should not be exceeded. We also advise to accelerate as slowly as possible. At the first periodic service it is very important to renew the oil, check if all bolts and nuts are fixed firmly, the leeway of the valves and check for oil leakage. We refer to our information about periodic services on our website for more information about performing periodic services. If the first periodic service proves everything to be fine, it will be ok to drive faster.

Also if a scooter has been runned in, we always advise to not to drive in full the first 10 minutes, to make sure the engine gets the change to warm up calmly.

Technical details
Leeway of the valves cold in and out  0.01 mm
Engine oil 4 stroke 10w40
When starting poorly, change main jet by 80